Installation of sinks of

Installation of sinks of
Installation methods. The modern design offers different solutions of installation of clay and metal bathroom equipment. Washrooms and dishwashing sinks can be established as permanently, not permanently. In the latter case the product is equipped with a special curbstone, together with other elements of the completed set. Such sink can be removed as required from a wall together with a curbstone. Usually, these products are equipped with mixers with the bottom water supply. Burning and cool water at all this arrives through flexible ekranirovanny hoses of various length. Such hoses are connected to a water pipe by a diameter of 0,5 inches.

Stationary fastening. If the sink is established permanently, then for its assembling use fastenings. Almost always they are offered by outlets together with a sink. It is dependent on a design of a clay product of fastening have the updatings, reminding typical крючья which enter into special openings on the sink case.

Installation of sinks of
Installation of stationary sinks. For installation of sinks of ware quite often use prutka from metal fittings a diameter 10 – 14мм, aggressively fixed in a wall. Installation of sinks and sinks is carried out, in the main thing, after the termination is repair – a system of works. On a wall (usually revetted tile) mark places of openings for fastenings. They should settle down at similar height and defend from each other at the distance providing the correct assembling of a sink. In own finished look it should be placed strictly horizontally, its upper edge is over a floor at height of 850-950 mm.

Installation of sinks of
Installation of fastenings. For a fixing element of fastenings use special iron bolts (screws) and plastic jams. In particular usmotritelny it is necessary to be at performance of openings in a clay tile. If you are not convinced of own possibilities, do not hurry up to undertake the puncher, the it is more with the drill of a huge diameter. For this purpose, to avoid tile damage at shock drilling, in – 1-x, take a drill with a pobeditovy drill of 3-4 mm. In – 2-x, do not work in a "shock" mode: plan future openings on small turns оковём ordinary drilling. Then it is possible to use a punching mode, thus in two steps: first the drill of a small diameter, and later – necessary for a plastic stopper. Essentially that the wall tile had no emptiness, on another at performance of openings its chips are probable, and the krepkost of fastening of a sink will be unreliable.

Seal of seams. After the sink or a sink absolutely will take the place, gaps between the case and a wall should be closed up silicone hermetic. It will exclude possibility of a zatekaniye of water in such microcracks.

Leave a reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>